● Gloss enhancer: This setting is available only for the HP DesignJet Z9
+
Printer series, if gloss enhancer is
installed, and if the loaded paper supports gloss enhancer. To use gloss enhancer ink and achieve superior
gloss uniformity, you need to install a separate kit available for the whole Z9
+
series.
● ALIGNMENT: Select where content should be aligned on the roll/sheet.
● NESTING: Turn nesting on or o (default: o), and select the gap between pages. See Nesting on page 18.
● COPIES: Select the number of copies of the job to be printed, from 1 to 99. Two or more job copies will be
sent to the printer as collated sets.
● Clip content by margins: If this is checked, the application assumes that the printer margins are zero, and
that it can print across the full width of the paper. However, the printer will not print anything that falls
within the actual printer margins.
● Cutting lines: If this is checked, additional marks are printed to indicate where the paper should be cut to
obtain the desired page size.
● Borderless: If your printer supports borderless printing and/or uses a specic trimming device, this setting
will be available when the conditions apply, based on the paper loaded.
TIP: Some paper types do not support borderless printing to the edges of the paper, but they may
support borderless printing using a vertical trimmer, if the printer has a vertical trimmer.
● V-Trimmer: If vertical trimming is supported by the printer, additional cutting lines are displayed in the page
preview. Make sure this feature is activated in your printer.
TIP: HP recommends using Borderless if selected manually and V-Trimmer if activated. Due to printer
margins, printable area may be reduced when using the vertical trimmer. If you prefer to avoid clipping the
image, deactivate it to use the whole surface of the paper.
● Remember last settings: If this is checked, the application will remember the last set of printing settings
that you selected, saving you some time and eort.
Printer status
Printer is ready
Printer is sending warning messages, but can print
Printer is sending error messages, and may not be able to print
Printer is disconnected: you cannot print to it
ENWW Settings 15