39
The machine doesn’t start and
the lights blinks irregularly.
• Fill the water tank and push buon to start.
• Check that handle is properly locked.
Lights blink while machine is
running.
• If coee or milk is flowing normally, this indicates the
machine is working properly.
• If only water is flowing, the machine is executing a user
request for either cleaning, descaling or emptying the
system. Refer to the corresponding paragraph in this user
manual.
Lights blink and machine is not
running.
• It will take some time before the coee flow comes out (due
to code reading and pre-weing the coee).
• Check that a fresh capsule is inserted in correct position,
that the handle is properly locked and push the buon to
start.
• Fill the water tank and push buon to start.
• Turn the machine to “OFF mode” by
pushing the coee buon for 3 seconds
and then push it again to turn the machine ON. Now wait
approximately 20 minutes to allow the machine to cool
down aer extensive use.
Lights blink irregularly.
Machine is not running.
• During regular Coee/Espresso preparation: 1) Unlock the
undamaged capsule is inserted in the correct position.
2) Check that the handle is in “LOCKED” position. 3) Check
that the water tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that
capsule is ejected. 2) Check that the handle is in “LOCKED”
position.
• During Programming Volume: 1) Check if a capsule has been
• If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the
machine back into outlet aer 10 seconds.
4. Close the head and press the buon to turn ON and press
again to start brewing. If problem persists, call Nespresso.
Descaling alert blinks or is fixed
orange.
• Machine triggers descaling alert according to your beverage
consumption. Descale the machine. Refer to section
“Descaling” according to your beverage consumption.
Rinse alert blinks orange. A rinsing cycle of the milk carafe is required, refer to section
“Milk Preparation & Daily rinsing”.
I cannot enter the Menu Mode
(Reset to factory seings/
Emptying the system before
a period of non-use/Water
hardness seing).
• Be sure to remove the milk carafe from the connector door.
• Be sure that the descaling pipe is not connected to the
connector door.
• Press and hold hot foam buon until descale and
rinse alerts blink.